Soap Holder - wall-mounted

This is a wall-mounted soap holder. Featuring a honeycomb base as found in many other printed soap holders, this one includes a backplate with reinforcement around the (single) screw hole, and fillets to add strength between back plate and base to avoid cracking. The base has been scalloped to prevent water from pooling on horizontal surfaces.

Revision 3-Dec-2018
TLDR: part now has an 5mm hole instead of 3mm.

I have printed this design for the first time. I used ABS, and printed at 0.1mm layer height with 100% infill. It took 25 hours. I was patient! The part lifted in the corners during printing, however this did not affect the overall function or aesthetic nature of the part; if anything it looks nicer. I did however make the hole too small (M3), and drilling cracked the part. I fixed it with superglue and will reprint if needed. I have edited the part to have an M5 hole so others do not have to go through that!