Thingiverse
Soap Holder with drain
von BigRed3234
4
Downloads
4
Likes
0
Makes
Available for dual extrusion as well as single extrusion. Dual extrusion is broken up into a bottom and top half. To make your life a bit easier, raise the top section by 5mm to have it fit perfectly on top of the bottom (just make sure that the drain slots line up, you may have to rotate 180 to have the drain slots line up correctly).
As always, I would love to see any makes or remixes from this design! Enjoy!
As always, I would love to see any makes or remixes from this design! Enjoy!
BigRed3234 veröffentlicht auch auf
2 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
