Thingiverse
Soap saver
von Unknown
5
Downloads
8
Likes
0
Makes
A tiny add-on for your typical soap dispenser: clip this tiny guy on and forget paying attention to not pump too much soap into your hands.
Fits soap dispensers with a diameter of approx. 6mm. To adjust pumped volume simply stretch in z direction in your slicer. In my case it is around 9mm high for a full pump length of 12mm, meaning it leaves 3mm to pump and it still is more than enough soap to wash your hands.
Fits soap dispensers with a diameter of approx. 6mm. To adjust pumped volume simply stretch in z direction in your slicer. In my case it is around 9mm high for a full pump length of 12mm, meaning it leaves 3mm to pump and it still is more than enough soap to wash your hands.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!