Thingiverse
Soap Tray (with drain)
von jdmmaster
0
Downloads
0
Likes
0
Makes
Printable soap tray with drains
Use:
20% infill
1.5mm shell thickness in both directions (can be less if printed in water resistant plastic [not PLA])
No supports
Use:
20% infill
1.5mm shell thickness in both directions (can be less if printed in water resistant plastic [not PLA])
No supports
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
