MakerWorld

Organizers

sodastream bootle holder

von Adamste · Organizers

45 Downloads

11 Likes

28 Makes

This project is soda stream bootle holder. Model was designed to hold empty bootle. It have thin wall, but probably it can withstand even bottle with liquid, but I did not try it. Best to print with PLA.Attach model to your cupboard using dual sided tape, the best high quality with high load-bearing capacity as tesa powerbond ultra strong or similar.Also if you prefer using screws, there is separate model that supports screw mounting. This model have 2 screw holes.

Holder holder mount mount accessory mounting mounting accessory kitchen kitchen 3d print 'kitchen kitchen acceories accesory organizer wall wall mount soda bottle soda sodastream bottle sodastream soda stream soda stream bottle

Kategorie

Organizers

Quelle

MakerWorld

Veröffentlicht

06.01.2025

Aktualisiert

30.04.2026

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat

STL

Material

PLA

Nachbearbeitung

Hardware

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

sodastream bootle holder

Ähnliche Modelle

Zur Sammlung hinzufügen