Thingiverse
Sofirn LT1 lantern base
door Cymond
2
Downloads
2
Likes
0
Makes
This is a simple base for the Sofirn LT1 lantern. It expands the base to approximately 4 inches to help reduce tipping.
You'll need a 1/4x20 screw (1/2 inch long) and a hex nut. Inset the hex nut from above, tighten the screw from below, and then twist the whole thing onto the base of the lantern. It is designed to easily twist on and off.
I printed mine in "natural" PLA on the bottom and black on top. I chose "natural" because it is translucent.
No supports needed. I also make the design public on Tinker for those who want to edit it.
You'll need a 1/4x20 screw (1/2 inch long) and a hex nut. Inset the hex nut from above, tighten the screw from below, and then twist the whole thing onto the base of the lantern. It is designed to easily twist on and off.
I printed mine in "natural" PLA on the bottom and black on top. I chose "natural" because it is translucent.
No supports needed. I also make the design public on Tinker for those who want to edit it.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
