Slicer Discord
Sofle V2 RGB Wheel Encoder Mount – Modelo 3D imprimible de Thingiverse Thingiverse

Sofle V2 RGB Wheel Encoder Mount

por bmatticus
2 Descargas
4 Likes
0 Makes
Ver Modelo
A simple mount for wheel encoder (EVQWGD001), There are 5 versions, I am using V5 currently, The V1 probably wont work as its a little too thick on the clips, also no where for your wiring to go. I never printed V2 or V3. V4 is a little tall and loose. V5 now has a cut in to help getting it into the cutout and two nubs on each side to try to hold it in, This seems to work reasonably well. It can slide left to right for sure right now and fit still isnt super tight, but seems OK.

For the encoder, you can see the specs from the source typcally, on mine the two "front" pins by themselves went to keypress. The 3 closest to these were COM (closes to front), A out, then B out. The fourth pin was/is unused.
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Polycarbonate
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección