Thingiverse
Soft-pick Case with Hinged Lid
por GrodenVR
7
Descargas
14
Likes
1
Makes
A case to store your GUM Soft-picks in. Sized for the 80-pack.
The lid should be printed vertically (as situated in the stl file) to make the hinge posts stronger (this is important for the installation step). I set a 5 mm brim in CURA to help stabilize the print.
To install the lid onto the case, line up the hinges with the lid in the closed position, insert one hinge pin into the hole and press the other corner down to click that pin into place.
I printed mine in PLA and it surprisingly didn't break during installation - the hinge tabs had just enough flex. PETG would be safer though.
The lid should be printed vertically (as situated in the stl file) to make the hinge posts stronger (this is important for the installation step). I set a 5 mm brim in CURA to help stabilize the print.
To install the lid onto the case, line up the hinges with the lid in the closed position, insert one hinge pin into the hole and press the other corner down to click that pin into place.
I printed mine in PLA and it surprisingly didn't break during installation - the hinge tabs had just enough flex. PETG would be safer though.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
