Solder Dispenser
door mread
1.8k
Downloads
1.3k
Likes
17
Makes
This takes a 250g reel of multicore solder and a solder sucker.
The base should print with no supports needed, as will the axle if it is printed with the end flat on the plate.
Update: added flux pen and most used solder tips.
The base should print with no supports needed, as will the axle if it is printed with the end flat on the plate.
Update: added flux pen and most used solder tips.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!