Thingiverse
Solder fume extractor
von CADjunkiii
35
Downloads
32
Likes
0
Makes
Based on the referenced remix-source (https://www.thingiverse.com/thing:17086/files - which currently won't show correctly elsewhere in the webapp), I created a modified version for a couple of reasons:
1. fixing the carbon-filter by edge notches instead of corner overhangs
2. be able to attach a control box (if needed) - spent two markings to drill for holes
3. be able to print without support - wasn't sure, if the original design was suited for it due to missing printing recommendations.
This design is suited for a 140mm PC fan.
1. fixing the carbon-filter by edge notches instead of corner overhangs
2. be able to attach a control box (if needed) - spent two markings to drill for holes
3. be able to print without support - wasn't sure, if the original design was suited for it due to missing printing recommendations.
This design is suited for a 140mm PC fan.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
