Thingiverse
solder holder
von bunjatec
183
Downloads
127
Likes
6
Makes
This is a solder reel holder, holds a reel op to 60mm wide and up to 60mm diameter with a hole more than 10mm diameter through the middle
(pictured reel is 54mm wide, 53mm diameter, 20mm hole through the middle.)
holder prints upright
bar prints upside down.
printed PLA on glass with heated bed.
No supports, no finishing, ready to use straight off the printer.
(pictured reel is 54mm wide, 53mm diameter, 20mm hole through the middle.)
holder prints upright
bar prints upside down.
printed PLA on glass with heated bed.
No supports, no finishing, ready to use straight off the printer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!