Solder paste syringe dispenser

Solder paste syringe dispenser, based on a design I found on the internet

https://www.youmagine.com/designs/manual-solder-paste-dispenser


I altered the design so that it is easier to print and assemble.


YOU NEED:

1 x M5 nut
1 x M5 threaded bar - around 100mm in length
1 x M4 nut (nylock type is best to stop it undoing)
1 x M4 x 35mm bolt or screw

Assembly is straightforward, as per the pictures.
Squeeze the handle to dispense solder paste, release and screw in the M5 threaded bar a little and then squeeze again, you will get the gist or understand after assembly.

All credit goes to the original designer.


There are two holders and plungers - one for 5cc syringes and one for 10cc syringes,
just print the one that you need.

Print one handle and one clasp .