MakerWorld
Other Tools
Voir le modèle
Solder Spool Holder - Simple
385
Téléchargements
91
Likes
243
Makes
Simple solder spool holder for the standard 54x57mm spool. No support needed. No glue needed. Please assemble after printed. Insert the sides into the groves on the base. Slide it at an angle until you reach the bottom. Tilt it into the slot and push in or tap it in. It will lock pretty tight. Make sure the spindle indentations are to the rear. Assemble the spindle rod together with the PEM in the middle. It should fit pretty tight so no glue is needed. Insert it into your solder spool and drop it into the assembled base and run the solder wire through the solder guide's hole.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !