Solder Station TS100

Thanks to sunbart for this https://www.thingiverse.com/thing:2814811

Modifications:
Extended iron tip holder as it doesn't get that hot and the copper is not really needed
Changed the bearings mount to use 10mm bearings
Changed the axle roller to suit roll of solder and available 10mm bearings (bearings screw into roller)


Note. I used very old "wood effect" PLA which I have loads of but It is a little brittle . The solder dispensing upright broke off at the base. I super-glued it together using 2 lengths of piano wire as re-bar inside the square infill.