Solder Tool Stand

Nothing very special, only my first try on modelling and uploading.Please leave feedback if you think something can be improved. Also about the print profile, as it is the default one, which printed without problems. This is a tool stand for my solder tools. The dimensions are:200mm x 65mm x 35mm It features:1x 23mm hole with bottom hole of 7mm3x 20mm holes with bottom hole of 16mm + 3mm center holes.+ accompanied by 2x 3mm holes for additional needle caps, for each 20mm hole.1x square 19mm x 11mm, same on bottom1x 9mm hole with bottom hole of 6mm The biggest hole is for a solder sucker.3x for solder, flux or solder mask syringe, with either an end-cap or a needle at the bottom.1x for a two-side brush.1x for either a pencil or in my case another brush. I have printed this on my A1 with BambuLab PLA Matte Black and 0.4mm Nozzle.Using the smooth plate to receive a similar texture as on the other side.Laying on its side to print without helping structures.Came out quite good, just a littl