Soldering cable / wire holder

Hi Makers! I sometimes have to less helping fingers and so I created this simple, but very helpful soldering tool that can hold a variety of different wires or cables properly in place while you are welding them together or cutting them to the right length. (In this case it's recommended to print 2 or more)There are fixtures for very thin cables down to 1mm up to thicker household cables of about 6-7mm, you just need to press them into place in the fitting location;-)On the bottom side there are locations to glue anti-move pads or maybe other fixtures and implemented screw holes to tightly secure it to a table etc. Compared to other similar models available it is much bigger and can hold more cables at higher distance, resulting in a larger work area and improved heat dissipation.The default material selected in the print profile is PETG, but you can also find a suitable PLA profile in the print profile section which has been tested too. Due to the bigger space the evoked heat won&