MakerWorld
Hand Tools
Vai al Modello
Soldering Helper
162
Download
32
Likes
101
Makes
I designed this to help holding wires while soldering. I found online that I liked but something common about them I did not was they liked to move around. So I designed this one so you can fill it up with sand, dirt, salt, etc. This makes the stand much heavier so it is much less likely to move. I have tested with 10 gauge and smaller. Print still functions if you do not want to fill with media. You just don't need to print the cover plate is all. Instructions:PrintFill with your choice (sand, salt, dirt, rocks, etc.)Check cover fitment. Make sure it touches on all corners.Apply super glue to lid or part.Apply cover to part.Place something heavy on part until dried.Enjoy, and don't forget your heat shrink! =)
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
