Thingiverse
Soldering Helper
by GarageGang
2
Downloads
2
Likes
0
Makes
Hello! It's my first project on the Thingiverse! And today I offer you to print this little helper.
All parts are easy printing.
Cotton cap with Screw are additional parts, so if you want to install this, just use a super glue or epoxide glue.
Diameter of cotton pad is 60 mm, flux is 20 mm in the wider part and 12 in the thinner part.
Important notes
All except the Base and the Flux stand I advise to print with 0.1 resolution because it has small screw. Secondly, Spool stand and Flux stand need a bit supports.
All parts are easy printing.
Cotton cap with Screw are additional parts, so if you want to install this, just use a super glue or epoxide glue.
Diameter of cotton pad is 60 mm, flux is 20 mm in the wider part and 12 in the thinner part.
Important notes
All except the Base and the Flux stand I advise to print with 0.1 resolution because it has small screw. Secondly, Spool stand and Flux stand need a bit supports.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!