Solid 2020/Tronxy X3 Spool Holder

I was in need of a strong spool holder, so i decided to make one as my first 3D printing project. The original acrylic one was taking up too much space so that one one of my main reasons for designing this.

You will need:

M3 x 12mm - 2 x
M4 x 8mm - 4 x
M3 Nut x 2
M4 Nut x 2
M4 T-Nut x 2

First attach the pole to the top of the shaft using the bracket and the M3 nuts and screws. Then the M4 Nuts will need sliding into place on the base of the shaft. Its a tight fit but it was intentional to avoid slipping. After that just screw the brackets into the base and onto the back right corner of your tronxy x3/x3a printer and you're good to go!