Solidoodle Workbench Z-probe Remake

This is a remake of the Solidoodle Workbench Z-probe to fit a different end stop switch that should allow a more precise and consistent measurement while also keeping slurry clear of the mechanisms. The original switch was just a plane Jane with the metal lever cut off. I designed this one to use this one from digikey. http://www.digikey.com/product-detail/en/0/SW1395-ND
The model should be easy to modify back to the original just make some measurements and adjust!

The piece was a bit tight in my holder so I still need to adjust for a looser fit so there wont be a need to shave it down. In the end I will designing my own version for an auto deployable probe so I never forget the Z-probe again!