Solidoodle Y-Axis Bracket

This is my version of the Y-Bracket.



Recommended to print at 100% infill for maximum strength.



Cut off support material to allow it to slip over the nut built into the frame. I've noticed a noticeable reduction concerning not only flexing of the bracket but dancing of the pulley on the bolt from side to side.



Your belts will have to be loosened, then retightened to replace the bracket. Check and see if the back pulley needs readjusting if your front pulleys are still moving around on the bolt.



This was printed on an SD2 with a stock heat bed. Please provide feedback if you have any issues or recommendations for improvement.