Sonic The Hedgehog

Sonic the Hedgehog 6cm tall, 3.7cm nose to tail and 3.5cm wide. Printed using the following filaments:BambuLab PLA Basic Jade WhiteBambuLab PLA Basic BlackBambuLab PLA Basic RedBambuLab PLA Basic CyanELE GOO PLA Beige NOTE, THIS MODEL HAS 5 COLOURS. I have set it so that you can load the white, red, cyan and beige to begin with. The print will pause after the shoes are printed and you can change the red for the black filament before resuming the print. This enables you to have all five colours with no issues. It's a long print but it came out great. It does require supports and take care when removing them. With multicolour prints there can be lots of waste particularly when you have multiple colours on the same layer. Printing multiple copies of it or other models that use the same colours at the same time will make the print more economical. I printed 3 in one go, which didn't have much of an impact on the total filament or time cost. Powered by PrintMon from MakerWorld (http