Thingiverse
Sonicare wall mount
von jrutgers
18
Downloads
6
Likes
0
Makes
Sonicare mount for glueing on the wall.
It should fit all Sonicare models.
It is advised NOT to print it on its back or upright: print it inclined, under 30 or 45 degrees, so that the clamp or base does not de-laminate, i.e. break.
It should fit all Sonicare models.
It is advised NOT to print it on its back or upright: print it inclined, under 30 or 45 degrees, so that the clamp or base does not de-laminate, i.e. break.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!