Slicer Discord
Sonnenschirm  – 3D-Druckmodell von Thingiverse Thingiverse

Sonnenschirm

3 Downloads
5 Likes
0 Makes
Zum Modell
I needed a stand for the following cardboard parasol.

http://www.carrera4fun.de/pdf/schirmjpg.pdf

I divided the pole into 2 parts, so there are many possible angles with the parasol. If you want it to be absolutely firm, glue should be quite helpful.

The foot is small in diameter for aesthetic reasons. Therefore, the umbrella may tip over under certain circumstances. Heavy washer, Patafix, glue, screw, there are many ways to fix the thing.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
2-teiliger Zusammenbau · aufwändige Nachbearbeitung
Hardware nötig
Supports 1/3
Zusammenbau 1/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
ABS
Nachbearbeitung
Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen