Thingiverse
sonoff NSPanel pro EU thin wall mount
por belgotux
0
Descargas
5
Likes
0
Makes
This is a support to put the front of ns panel pro directly to the wall!
It needs to be powered by 5v (only 4 pins are used on the 2mm 2x4pins connector).
A tube is behind the support to the patchpanel in my case, on EU box needed for 230v.
This is thin, only 5mm behind the screen is needed (for the pins connector essentially).
See the photo for the polarity of the wires.
## Needed
- 2 screws 3mm diameter
- 2x0.75mm² wires for
It needs to be powered by 5v (only 4 pins are used on the 2mm 2x4pins connector).
A tube is behind the support to the patchpanel in my case, on EU box needed for 230v.
This is thin, only 5mm behind the screen is needed (for the pins connector essentially).
See the photo for the polarity of the wires.
## Needed
- 2 screws 3mm diameter
- 2x0.75mm² wires for
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
