Thingiverse
Sonoff PIR Case
por Bassmanham
31
Descargas
15
Likes
0
Makes
This is a case to hold a Sonoff basic module, a PIR sensor and a DHT temperature/ humidity sensor.
The lid is held on using 3mm bolts. The holes in the lid will probably need opening up a little to allow the bolts through.
The DHT sensor is best located away from the case as it may give high readings due to it sensing the temperature of the sonoff module itself.
The sonoff is programmed with Tasmota firmware and is controlled and monitored using Openhab2.
The lid is held on using 3mm bolts. The holes in the lid will probably need opening up a little to allow the bolts through.
The DHT sensor is best located away from the case as it may give high readings due to it sensing the temperature of the sonoff module itself.
The sonoff is programmed with Tasmota firmware and is controlled and monitored using Openhab2.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!