Sonoff SWV wall mount

I didn't like the Sonoff SWZ hanging off my outdoor tap as it didn't look right so decided to create a wall mount to have it close to the wall. To do this I use a small piece of hose to go from the tap to the top of the Sonoff and then use this mount to flush mount it to the wall.

The Sonoff valve fits snuggly inside the unit and it is pulled enough away from the wall to allow the battery compartment to be removed from the unit either to remove the valve or to replace batteries.

It was printed on my K1 Max printer without supports in its upright position, you may need to add a rip just to keep it attached to the build plate as it becomes top heavy while printing but the overhand was kept low to remove the need for supports.