Sonos Ray Stand

This pair of stands was designed to lift the Sonos Ray by either 3.5cm or 6 cm off a surface (two different models are attached depending on your application). This is for aesthetics AND to improve IR remote performance (by lifting the IR sensor above the shelf surface). You will need two M5x16mm bolts with washers to attach. I also added rubber "dots" from Home depot to the bottom to help stabilize and prevent "vibration creep". The attached pictures with the speaker show the 3.5cm (short) version. The 6cm version is shown laying on the counter (I decided the 6cm version was too tall for my application). These printed easily on a cheap XYZ printer with 15% fill and contoured supports; my surface finish in the pictures is not great, but I don't expect much from a $200 printer. Final stands are surprisingly strong. The short version is printable as a pair, the tall you will need to print twice (couldn't fit two of the tall version on my small printer bed at once).