Sony weather-resistant multi-interface cover

This is based on Daniel Rauber’s cover https://makerworld.com/en/models/137269-hot-shoe-cover-sony-multi-interface-shoe-cover?from=search#profileId-149371 , with an added top section that provides better protection against water intrusion and also locks the cover in place. Should be printed in TPU 95a (softer might work also), as it needs to flex a little for install/removal.I shoot wildlife and sports, so being out in wet weather is not uncommon. I’ve used other covers, but over time, find they tend to slide back, uncovering the front contacts, or just completely falling off. This model has a small lip under the front edge that locks it in place.There are three covers on this build plate. One is blank, one with an embossed ‘A’ and one with a ‘B’. I shoot sports with two A1s and I use this marking system to ID the cameras. I've tested this model on an A7RIV and A1 mark 1.