Sopwith Camel Remix

UPDATED: F3 and F4 (added cuts for captive nuts and cabin latch) + revised tail skid.

Remix of https://www.thingiverse.com/thing:3951370

See https://sopwithcamel3dmodel.wordpress.com/ for full assembly and print instructions.

NOTE: THIS IS FOR THE 1.25 (1/8 SCALE) VERSION ONLY!

Guns and dummy motor remixed from https://www.thingiverse.com/thing:4228878

Pilot remixed from https://www.thingiverse.com/thing:3065972.

These files are additions to or replacements for the originals.

Both wings and everything aft of F4 is LW-PLA, as is the hump and pilot figure. Otherwise it will not balance without tons of weight in the nose.

Print Hump and Pilot with some infill.

Glue the bottom 2 captive nuts behind the firewall before gluing the firewall to the plane! The top 2 go on the battery tray.

Glue the ESC bracket on the front of the firewall and secure the ESC with the 2 cable ties.

Use 5x5x5 magnets to secure the cowl.

Use 3mm screws and nuts to secure the mot