Other STL Download - Sortierbox mit 10 Fächern - Sorting box with 10 compartmentsby Mülly_Design

English:- This model is a simple sorting box with 10 compartments.- The front is equipped with an additional lettering plate that is simply glued to the lid. It is purely aesthetic and can be optionally omitted. Personally, I don't like the 3D printed side that rested on the print bed as a visible surface, and using the method of printing an additional plate, it can be blended very well and even made two-colored with a PAUSE function in the G-code.- The hinge works without any additional components. It is hooked in at an open 135° angle and rotated with a slight adjustment. It rotates cleanly and can only be unlocked and removed again at this 135° angle. It can also be used to hold the lid in the open position. The lid does not require any support. The box does require a little support for the hinges to improve precision. You can also rework slack filament with sandpaper to ensure smooth movement if it gets stuck a bit.- The cover plate must be paused after the fourth layer to swap colors if desired. Some slicers offer pause commands that can be specified. I didn't find this function in the Creality Print slicer. However, after creating the G-code in the slicer, you can simply open the G-code in the text editor and, with a bit of searching, find the point where the fourth layer is finished and the fifth is being prepared. Simply insert a separate line there with the "PAUSE" command without quotation marks. Import this G-code back into Creality Print and then send it to the printer.- There are three holes for magnets planned in the lid and the box. These are optional, of course, but without the magnets, the lid will only stay closed if the box is placed on a flat surface. There are no additional closures or hooks. If a closure is desired, you will need to purchase six Ø3x3mm cylinder magnets. You may need to rework the holes a bit with a drill.- Have fun with the box.Settings: Creality Hyper-PLA Standard Material Profile, 3 wall lines, 0,2 layer height, high speed po