Thingiverse
Source One HD Dimond
door Andreg97
6
Downloads
3
Likes
0
Makes
Slammed my Source One V4 to 25 mm, it looks very cool, but the camera angle is limited. I designed new camera plates to keep the frame stiff, you can print them, I did that for testing and later i CNC milled them in titanium. Print the spacers in TPU, you will need them for the Vista camera.
The Vista holders are light and under this mount is enough space for passing cables. You need to place them correct, as you can see in the screenshot. Use M3 screws and nuts.
The arm guards are also soft mounts for the motors.
The GPS, Antenna and XT60 mount is a bit tricky, but it works well for me. You will need to place a tube or something under it on the standoff, otherwise it will slide down when you plug in the battery.
I designed this Cable clips to hold the motor wires down on the arm. Just cut them after printing on the back side, place them on the arm and meld the TPU together again with the soldering iron with about 230 °C. I got a very clean look with them, and I have never se
The Vista holders are light and under this mount is enough space for passing cables. You need to place them correct, as you can see in the screenshot. Use M3 screws and nuts.
The arm guards are also soft mounts for the motors.
The GPS, Antenna and XT60 mount is a bit tricky, but it works well for me. You will need to place a tube or something under it on the standoff, otherwise it will slide down when you plug in the battery.
I designed this Cable clips to hold the motor wires down on the arm. Just cut them after printing on the back side, place them on the arm and meld the TPU together again with the soldering iron with about 230 °C. I got a very clean look with them, and I have never se
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!