Thingiverse

Sous Vide Immersion Circulator Wall Bracket

por critter42

17 Descargas

6 Likes

0 Makes

I got a Monoprice Strata Sous Vide immersion circulator, but don't have any good place to keep it and wanted it handy as I find I'm using it a bunch, so I made this bracket for it. The screw holes are sized for #8 screws. On the right is a ledge for hanging the clamp and on the left is cord storage. This should also fit the Anova circulators and maybe others that are 65mm in diameter or less.

Note: It is not a snug fit, but I just want it to hold, not struggle to get it in and out. you can probably add a piece of foam weather stripping or something if you want a tighter fit. I also ran it through Meshmixer and added my own supports for the power cord stanchion because the Slic3r support generator was just about useless. The screw holes should accept #8 screws, but will require a little persuasion or an appropriate drill bit as I made the tolerances a little tight.

Anova Anova Sous Vide bracket circulator immersion immersion circulator monoprice sous vide strata wall mount Anova Anova Sous Vide bracket circulator immersion immersion circulator monoprice sous vide strata wall mount

Fuente

Thingiverse

Lo que necesitas para imprimir: Intermedio Baja confianza

Pieza única Tornillería requerida

Soportes 1/3

Ensamblaje 0/3

Ajustes 1/3

Tamaño de cama 0/3

Postproceso 1/3

Impresora

FDM / FFF

Formato de archivo