Southpaw 75 Case

*If your printer is not square, these tall prints might not be dimensionally accurate and lead to the two halves not fitting perfectly. If that's the case, you might need to print the Gap Filler and solder that to the other parts.*

**Overview**
This is a case designed to fit the Southpaw 75 keyboard. This is built around the Holyswitch Southpaw kit, not sure if it fits with the other version. It prints in two halves and is joined together with a few dowel pins.



*TL;DR Print everything and figure out how the parts fit with the case. The build should be straight forward, but read the full description if you want some guidance.*

**What You'll Need**

4x M2 10mm standoffs
8+ M2 screws (not sure what length it is, but whatever came with the kit)
Super glue, E6000, JB Weld, 5-minute Epoxy, etc.
Optional: soldering iron


**Print Settings**

Print both halves and 4 dowel pins.
Make sure the two halves are oriented on the outer ends (holes facing up). See Print