Thingiverse
Soviet Bus Stop 4 easy print
von WindhamGraves
39
Downloads
43
Likes
0
Makes
Come support these models over on [Patreon](https://www.patreon.com/WGraves)
**Buy my time, Not my models.**
Easy to print Soviet Bus Stop 4 1/100 scale. Some details have been changed for looks/ printability. I have no idea whether the scale of this is correct or not, I did it from a single photograph that doesn't have any scale objects in it.
The ring around the bottom is to make the first layer print better, and to add some adhesion to keep the parts attached before they connect. Make sure to have "make printable" turned off, it will mess up what will eventually be the top of the model. (this model prints upside down and the legs attach to the places with the little round mounts)
This would probably work pretty well in a scifi setting as well/ or a 1950-60s worlds fair esque thing...
Image is of model printed in 1/52. With 3d breed fig for scale. (I know, wrong time period)
Scale by 1.56 for gaslands / hotwheels / 1/64
Scale by 1.786 for 28mm / 1/56 || Apparently
**Buy my time, Not my models.**
Easy to print Soviet Bus Stop 4 1/100 scale. Some details have been changed for looks/ printability. I have no idea whether the scale of this is correct or not, I did it from a single photograph that doesn't have any scale objects in it.
The ring around the bottom is to make the first layer print better, and to add some adhesion to keep the parts attached before they connect. Make sure to have "make printable" turned off, it will mess up what will eventually be the top of the model. (this model prints upside down and the legs attach to the places with the little round mounts)
This would probably work pretty well in a scifi setting as well/ or a 1950-60s worlds fair esque thing...
Image is of model printed in 1/52. With 3d breed fig for scale. (I know, wrong time period)
Scale by 1.56 for gaslands / hotwheels / 1/64
Scale by 1.786 for 28mm / 1/56 || Apparently
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!