Thingiverse
SOVOL SV01 E3D Hemera Mount.
von J-Max
8
Downloads
1
Likes
0
Makes
This is the combo I use for the E3D Hemera extruder on the SOVOL SV01.
I still have some upgrades to do :
- Filament sensor mount
- Cable holder on the X motor mount cover.
/!\ This combo includes Tarasque1024's Hemera_5015_Fan_Mount_45deg_V4.stl
https://www.thingiverse.com/thing:4039235 which works perfectly.
/!\ This combo includes my X Motor Cover from my SOVOL SV01 Savior's Kit.
https://www.thingiverse.com/thing:4730352 which allows to maximize X travel to +300mm
The design try to minimize the amount of work on the genuine carriage: it mostly uses the holes already drilled into SOVOL's blue carriage. There's only one hole to drill (M3). As I tried to save the same Z-height and same Firmware configuration*, and minimize the holes to be drilled, you'll have to dismount the carriage to fix the hemera from the back of the carriage.
________________
Firmware changes :
- X travel 300mm
- Esteps 376mm (eventually to be adjusted)
____________________
Recommended
I still have some upgrades to do :
- Filament sensor mount
- Cable holder on the X motor mount cover.
/!\ This combo includes Tarasque1024's Hemera_5015_Fan_Mount_45deg_V4.stl
https://www.thingiverse.com/thing:4039235 which works perfectly.
/!\ This combo includes my X Motor Cover from my SOVOL SV01 Savior's Kit.
https://www.thingiverse.com/thing:4730352 which allows to maximize X travel to +300mm
The design try to minimize the amount of work on the genuine carriage: it mostly uses the holes already drilled into SOVOL's blue carriage. There's only one hole to drill (M3). As I tried to save the same Z-height and same Firmware configuration*, and minimize the holes to be drilled, you'll have to dismount the carriage to fix the hemera from the back of the carriage.
________________
Firmware changes :
- X travel 300mm
- Esteps 376mm (eventually to be adjusted)
____________________
Recommended
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
