Sovol SV01 LCD Riser

I made this wedge in preparation for an enclosure. I needed the LCD screen off of the printer. Essentially, I just measured the angles where it sat naturally on the printer, and the height from my table. The I added a cutaway for the cables. This wedge, and all measurements, utilize this project:

https://www.thingiverse.com/thing:4191292

I would say the cover in that project is necessary to print, because I don't know how a bare lcd would work. The toolholder is optional. Once all the parts are printed, you can hold it in place with double-taped velcro. And finally, you will have to extend your IDC 10-pin cables, because they are not long enough. You'll have to flip the printer over, and open up the bottom. I used this kit and cable set:

https://www.amazon.com/gp/product/B07V42WYNB/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

https://www.amazon.com/gp/product/B07P77YNWB/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

There are two files. You can print a blank wedge, o