SP75 foam gasket mount case

After a few revision and test print, this project is finished! This is a case made for the PCB sandwich kit Southpaw 75.


__Feature:__
-"Gasket" mount with 1/8" foam tape
-Fits small printers like the ender-3
-Split into four part, only need support touching the build plate. (turn this option on in cura)
-Wide bezel around the case with the SP75 logo on the top.
-5 degree typing angle


__Build and parts__
The keyboard case will need five(5) m3∗12 screw, five(5) m3∗14 screws or longer and 1/8" thick foam tape. Use the longer screws for the five screw on the top side. I chose foam tape because they are pretty easy to find and cheap to buy. You can alos try out other material just note the thickness should be around 1/8 of an inch. The foam tape I used is https://www.amazon.ca/gp/product/B07D7LDMYQ/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

The build is pretty straight forward, print all four part with the flat side on the left and right on the bed(