Space 1999 Eagle Transport

Space 1999 Eagle Transport

The design was meant to be printer friendly and is composed of individual parts that are glued together.

All parts are aligned for intended print orientation.

Parts:
- Cockpit
- Body x2
- Mid
- Side Right x2
- Side Left x2
- Foot x4
- Engine
- Expander x4
- Peg x10


The individual parts are connected with pegs and glued. The pegs are mainly used for proper alignment. The pegs may need to be adjusted if it doesn't fit. Cut away any blemishes or carefully use a heat gun to adjust peg.

All parts were printed with layer height 0.1 mm and infill of 10%.