Thingiverse
Space Launch System
von Edu_electronics
0
Downloads
1
Likes
0
Makes
As a constant learner I started some time ago an udemy course based on the design of the one of the most famous NASA’s Space Launch System.
Moreover, I wanted to go a little bit further and I designed an espirall Led support inside of the SLS in order to give it more colorful (Note: 1m LED stripe was bought appart). If you need more information about the process, don´t hesitate and contact with me ;)
Finally, I leave here the link to this course just in case you want to make it also :)
Course: https://www.udemy.com/course/fusion-360-design-for-3d-printing/?couponCode=KEEPLEARNING
Moreover, I wanted to go a little bit further and I designed an espirall Led support inside of the SLS in order to give it more colorful (Note: 1m LED stripe was bought appart). If you need more information about the process, don´t hesitate and contact with me ;)
Finally, I leave here the link to this course just in case you want to make it also :)
Course: https://www.udemy.com/course/fusion-360-design-for-3d-printing/?couponCode=KEEPLEARNING
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!