Thingiverse
Spaceship Corridors
by NTaW
233
Downloads
127
Likes
0
Makes
**Check Edits**
Here are some Spaceship corridor tiles that I have designed for use with a variety of tabletop games. Each of the five corridor types have two holes designed for 2x1 magnets, at this point I haven't tested this since I'm still waiting on magnets to arrive but I will repost any fixes necessary once I can test the fit. All five floor tiles and the bulkhead halves have been successfully test printed on my Ender 3 Pro and CR-20 Pro printers without issue using both Cura and Prusaslicer. When I printed the bulkhead halves I adjusted the first layer to be .3mm to make them the right thickness otherwise everything was printed at .2mm layer height. While I printed in halves and glued them together I have also included the full bulkhead piece in case that is useful to anyone; they sit in place in the slots at the edges of corridor pieces and are held upright at present even without magnets keeping pressure on. No supports were used while printing, the lights on the corridor w
Here are some Spaceship corridor tiles that I have designed for use with a variety of tabletop games. Each of the five corridor types have two holes designed for 2x1 magnets, at this point I haven't tested this since I'm still waiting on magnets to arrive but I will repost any fixes necessary once I can test the fit. All five floor tiles and the bulkhead halves have been successfully test printed on my Ender 3 Pro and CR-20 Pro printers without issue using both Cura and Prusaslicer. When I printed the bulkhead halves I adjusted the first layer to be .3mm to make them the right thickness otherwise everything was printed at .2mm layer height. While I printed in halves and glued them together I have also included the full bulkhead piece in case that is useful to anyone; they sit in place in the slots at the edges of corridor pieces and are held upright at present even without magnets keeping pressure on. No supports were used while printing, the lights on the corridor w
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
