SpaceSphynx

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm  The Model is 200x200mm in size. You can adjust the X and Y but the Z must remain the same.  You may print at higher layer heights below the Min Depth of 0.48mm  Actual Depth is 2.2mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.3 PLA BambuLab Matte Ash Gray Transmission Distance: 1.5 PLA BambuLab Basic Purple Transmission Distance: 2.6 PLA BambuLab Basic Green Transmission Distance: 2 PLA BambuLab Matte Marine Blue Transmission Distance: 0.5 PLA BambuLab Matte Mandarin Orange Transmission Distance: 3 PLA BambuLab Matte Ice Blue Transmission Distance: 3.5 This print uses 7 unique filaments. Substitute to suit your needs. Swap Instructions: Start with Black At layer #7 (0.64mm) swap to Ash Gray At layer #9 (0.8mm) swap to Purple At layer #12 (1.04mm) swap to BambuLab Green At layer #15 (1.28mm) swap to Marine Blue At layer #21 (1.76mm) swap to Mandarin Orange At layer #25 (2.08mm) swap to Ice Blue for the rest.