SpaceX Dragon Capsule

This is a model of the SpaceX Crew Dragon V2.0 I designed it so that it could be easily printed in two colors using only a single extruder. I have included a picture outlining what each part is, and its location in the model, as well as a picture showing the proper orientation for printing the white parts, and a picture showing the proper orientation for printing the black parts to reduce the risk of warping or error. The only piece that should need supports is the Dragon_Capsule_Bottom where the Draco engines are. I printed mine in ABS and used ABS cement to put all of the pieces together, however if you are printing with PLA, a little bit of superglue will hold everything together. Be sure when gluing to put some on the pin, as well as a little bit on the faces between the parts to help prevent the pieces from twisting.


Steps for Assembly:

1.) Insert and glue the Capsule_Alignment_Pin fully into the Dragon_Capsule_Mid. *Note: The alignment pins are only to keep the pieces cen