SpaceX Helmet

Modified form of Macktruck's design, reduced to 4 large parts (plus the visor mold) with pegged thicker portions between the front and back sections for easier gluing.

Visor form can be printed in its current orientation or laid flat. Either way use supports to fill the open edges

The top and bottom go together via a post on the top section that fits into a hole through the bottom section, which also allows it to open

A fairly large print area is required, as I used almost the entire print area of my Ender 3 (just under 9 inches on a side)

Changes still needed:
~Top lip of the Bottom_Front part currently requires a lot of sanding to not catch on the bottom of the Top_Front piece when opening