Spade Drill Bit Case

This is a Spade Drill Bit Case that I designed when my original one broke. It is designed for 8 bits up to 32mm width. The spacing is pretty tight for 32mm so will need modifying for any other size. The bits are held in with magnets and the latch mechanism was deigned to work with the same size magnets.

Printing:
My brother printed it so unsure on the details. For the 2 tone he just stopped the print after the first few layers then changed the filament.

Additional Materials:
- 18 Disk magnets (Max size 10mm dia x 2mm height) with one face being north and the other south.
- 2 x (10mm long 1.5mm dia) metal pins. (I used cloths line peg springs and just cut out the straight parts)
- Optional - 100mm x 5mm dia metal pin to replace the pin model supplied (works with the printed one in a prototype quite well. I just went over the top and bought 2 x 40mm pins)

Body Assembly
1. Glue 16 magnets in the back of the case to hold the bits in place.
2. Clean out the hinge holes wi