Slicer Discord
Spaghetti Shredder – 3D-printbaar model van MakerWorld MakerWorld
Robotics

Spaghetti Shredder

4 Downloads
6 Likes
0 Makes
Model downloaden
Spaghetti too long? No problem.This Shredder breaks your Spaghetti into smaller pieces.Sounds stupid? Well...Every part can be printed without support, but they must be rotated correctly.The shafts are press fitted into the wheels. The tolerances are quite tight, meaning they might be too tight or too loose. In that case shaft1 can just be removed as it is not really necessary.I used these 3-12V motors (same model available from different sellers): https://www.amazon.com/dp/B08CMPBXNL/You will need the following screws (and nuts). You can also use longer screws for all, they will just stick out more.2x M3x306x M4x183x M4x206x M4x30You will need to cut some plastic for the covers. One piece that goes on the wheel and one that goes on the shoot. I just used the plastic case that came with the motors, but you can use any light plastic.Enjoy!
Categorie
Robotics
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Waarom?
print-in-place ontwerp · geen supports
Zonder supports Print-in-place Hardware nodig
Supports 0/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie