Sparkcube radial fan mount

This is a remix of the "Alternate fan mount system" found here http://www.thingiverse.com/thing:1734379

Because I use the original Sparkcube X-carriage, I redesigned the fan mount plate.
You can easily adjust the height of the plate to match the length of your hotend.
I use 2 x 50mm radial fan (blower fan)

I use a E3D Lite6 and it is mounted underneath the X-carriage. For cooling the hotend, I use a 40mm fan (fanduct can be found on thingiverse).

You can use the fan duct of the origin thing or use one of the attached fan ducts. Because the initial fan duct seems to be too short for my hotend, I designed different variants. Also I increased the height of the fan duct mount flag.

1. Sparkcube_Radial_Fan_duct_long_wide_23mm is a longer version, the inner distance of tubes is 23mm. It is very close to the heater block of E3D Lite6-
2. Sparkcube_Radial_Fan_duct_long_wide_30mm is also a longer version, but the space between the tubes is 30mm wide.
3. Sparkcube_Radial_Fan_duct