Spartan sword (Leonid sword)

300 Movie-Inspired Spartan Sword (Leonid's Sword)
This design, inspired by the sword from 300: Battle of Thermopylae, has been optimized for 3D printing and easy post-processing.

Printing recommendations:
For Bambu Studio users, use the provided profile for optimal results.
Otherwise, follow the part orientation shown in the image.

- Use glue stick for improved bed adhesion.
- Utilize supports and rafts as needed.
- Print with 3 perimeters for enhanced durability.
- PLA is recommended for easy post-processing. PETG may be preferable for handguards for increased strength.
- Two grip versions are available: "grip" for leather straps and "grip no leather" (larger) for use without straps.

Hardware (for best look):
- 2x M3x20 or M3x25 mm screws.
- 2mm thick leather straps.
- Superglue
- Sand paper
- Putty
- Primer spray
- Spray paint

Assembly:
1) Sand all parts for a smooth finish.
2) Dry-fit the grip and handguards, then disassemble.
3) Apply thin double-sided tape to both sides of th