Thingiverse

SPC 95X FPV VTX Canopy

von kmmcca

3 Downloads

1 Likes

0 Makes

This is a cover I designed to install on an SPC 95X micro quad. I wanted something with ventilation to protect the VTX I installed on the top of the quad. The rear screw installs directly to the existing frame hardware. The front screw needs a small (1.5mm) hole drilled in the frame to accommodate a screw.

Best if printed upside down. May need supports for the screw tabs.

case vtx fpv FPV Antenna fpv camera FPV drone fpv vtx microquad micro quadcopter Mini FPV Quadcopter vtx

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat

STL

Material

ABS, Polycarbonate

Nachbearbeitung

Hardware

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

SPC 95X FPV VTX Canopy

Ähnliche Modelle

Zur Sammlung hinzufügen