Thingiverse
SPC Maker Runcam Micro Mount
von KiLLiN-TiMe
46
Downloads
36
Likes
1
Makes
TPU is Recommended but I guess you can use what ever you have and can print.
The SPC Maker 95GF is one of the best micro quads on the market, but the camera angle is way too low. This will set it at 30 degrees.
I removed the stand offs and the carbon fiber supports for the camera to install. Screw the top and bottom plate directly into the TPU.
The SPC Maker 95GF is one of the best micro quads on the market, but the camera angle is way too low. This will set it at 30 degrees.
I removed the stand offs and the carbon fiber supports for the camera to install. Screw the top and bottom plate directly into the TPU.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!